Click photo to enlarge
Page Views: 2289
Oct 29, 2014
Nov 24, 2014
Add to Garage
Send to a Friend
Get a loan in 15 mins
Free CARFAX Check
Get a Free Quote on a New Mustang
|Vehicle Info -
||2001 - Get Insurance
||5.1L 2V SOHC
CARFAX Record Check
||Gray / Blue
|Power Steering, Power Brakes, Power Windows, Power Locks, Power Mirrors, Antilock Brakes, Air Conditioning, Cruise Control, Air Bags - Driver, Air Bags - Pass, Security System, Rear Defroster, Tilt Wheel, Tinted Windows, Rear Spoiler, Tachometer, Keyless Entry, AM/FM, CD player
|Description: 2001 Mustang
I will do the best to list all add-ons & work done, any areas of concern, deficiencies, damages, etc. I will do my best to describe everything in detail to the best of my ability. I’m selling because I really need to downsize….family comes first and I have too many toys and not enough time or space. She usually sits in the garage most of the time, barely driven or enjoyed. ALWAYS GARAGED. Time to go to someone else who will enjoy her and finish her up like I dreamed of doing. What receipts I do have will be included. The car has had tons of work done to it, but is not perfect as it is 13 yrs old. Inspections welcome!
2001 Mustang GT / Saleen Clone 72,650 original miles. Driven less than 7,000 mi in the last 4 ½ years.
- Built 5.1 L HCI Stroker Shortblock 2V SOHC. Bored and honed 45 degree cross-hatch pattern. Manley 23cc Dish Pistons. Forged Steel I-Beam Rods, 5.993” Rod Length. Forged Cobra 8 Bolt 3.750” Stroke Crankshaft / Stock stroke 3.543”. Clevitte 77 Bearings. HO Oil Pump and pick up tube. Multi Layer Steel Head Gaskets. Complete rotating assembly has been balanced: Crankshaft, Pistons, Rods, Flywheel, Pressure Plate, and Harmonic Balancer all to 1 gram of another. Sticks of Mallory added to crankshaft for weight. Stock Heads, 3 Angle Valve job – grind Seats & Valves. Have been freshened up and Deep Heat cleaned.
- Innovators West Harmonic Damper 15% Overdrive, w/Dual Crankshaft keys & Super Duty Hub option. (Gained 90 hp with this alone.)
- Procharger P1SC supercharger @ 15.26 lbs of boost.
- 2001 Bullit intake manifold.
- Accufab Throttle body.
- EGR has been completely deleted. There is absolutely no exhaust being recycled back into the intake. It has all been deleted…no more gunking up your intake and engine with exhaust gases. Vents through a custom breather.
- SCT BA2400 90mm Mass Air Flow Sensor.
- JLT Cold Air Intake and pipe.
- MSD Coil Pack.
- NGK TR6 plugs gapped @ .32.
- Siemens Deka High Impedance 60lbs Injectors, #107961. Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min. Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min.
- Aluminum overflow coolant tank.
- High flow Blue Anodized fuel rails.
- Ford SuperChip.
- BBK Chrome Valve Covers.
- The compression is 8:5:1.
- Last conservative Dyno tune was at; street - 443.46 rwhp & 456.56 rwtq. Race – 464.20 rwhp & 472.62 rwtq.
Recently Added in the last 4-6 months:
- BGG Performance 8 rib pulley upgrade. Switched the procharger pulley from a 3.20” to a 2.90”. WILL be making a few more lbs of boost now. I can definitely feel the difference with that smaller pulley, the boost comes on @ lower rpm and faster. Does not exceed the max impeller speed.
- Innovators West Harmonic Damper 15% Overdrive, w/Dual Crankshaft keys & Super Duty Hub option. Gained 90 hp with this alone.
- Meziere Electric Water Pump. Not the $300 regular one, I got the one for supercharged applications, almost $600.
- Added a drain line to the P1SC because I hated changing its oil and it dripping on belts and eating them away and or belt slip (ask me how I know). The line works great.
- Thump RRR Racing Tensioner. No more belt slip or any of that garbage! Lifetime warranty with Thump RRR Racing!
- Custom Breathers…Stainless Braided Lines with AN fittings mounted on each valve cover and both leading to a MOROSO Catch can mounted near the coolant overflow tank.
- Stainless high pressure power steering hose w/AN fittings.
Other add ons/mods:
- Kenne Bell Boost-a-pump with the control switch mounted on the driver’s side of the center console.
- Cobra fuel tank with twin cobra pumps.
- Ford racing aluminum drive shaft.
- Shift light mounted on the dash between the turn signal blinkers.
- Rear fenders have been professionally ‘rolled’ because they used to cut into the tires whenever I would hit a bump at a decent speed. Very clean look.
- 3:73 gears.
- Moser 8.8 Axles 31 Spline.
- UPR Caster Camber plates.
- Upper and lower Control arms w/weight jackers.
- Maximum Motorsports Panhard Bar (axle mount, chassis mount, aluminum rod).
- Maximum Motorsports Heavy Duty Torque –Arm 8.8 axle (Torque-arm main tube, crossmember, & hardware kit).
- Subframe Connectors.
- Drive Shaft safety loop.
- UPR Chrome Moly K-member Kit with A-arms.
- Bumpsteer Kit. (I want to say they are UPR but I can’t remember).
- Adjustable Coil Overs on front and rear.
- Maximum Motorsports Front & Rear Sway bars.
- Front and rear brakes have less than 200 miles on them.
- Front = Wilwood Forged Narrow Superlite 6R Big Brake Front Brake Kit with stainless steel flex line kit. 6 Piston & 12.88 rotor diameter
- Rear = Power Stop Street Warrior Brake Kit. Drilled & Slotted Rotors.
Rims and Tires:
- Authentic 18” SALEEN chrome rims wrapped with NITTO 555R drag radials. Front =265/35/18. Rear = 305/40/18.
- Rear exhaust tips are aesthetic only! Exhaust are turn downs.
- BBK H-Pipe.
- No Cats!!! Deleted!
- BBK Long Tube Headers.
- Electric Cut Outs.
- Tremec 3650 5 spd.
- 11” Cobra Clutch. It’s like butter when you press the clutch, very light clutch. Was balanced with the motor when motor was built.
- RCI (Racer’s Choice Inc.) 5 point harness racing seats.
- Pioneer Flip up radio flat screen with remote. DVD/CD and XM ready. No amps or subs.
- The Boost-a-pump wire runs out the rear seat and under the driver’s seat. Never bothered to hide it since I don’t carry passengers.
- AC blows cold
- I keep the cruise control cable disconnected because I never use it, takes a few seconds to put back on.
- Registered through May 2015 in CA.
- There will be procharger oil with the vehicle in the trunk.
- The key for the rims will be in the center console.
- The radio remote will be in the center console (no batteries).
- SCT Programmer with 3 stored tunes. Use only the two ones from Nexgen Street or Race (latest tunes), programmer will be in the trunk.
- Do not slam the trunk. Doing so repeatedly with cause the spoiler to become loose. I learned the hard way.
- I have only use Mobil 1 Full Synthetic 5-30.
- Optima Deep Cycle Battery in trunk.
- No spare or jack!
- HOLD down the AUX button on remote to pop trunk.
- Alarm self-arms in 30 sec after all doors are closed. If you are working on it, disconnect the battery or leave the door slightly ajar so it doesn’t arm every 30 seconds. Alarm is very sensitive, kick the tires and it will go off.
- I keep wooden blocks in the trunk to drive onto so I can get a jack underneath. Included.
- I made a makeshift bracket for the upper radiator hose using plumbers tape because after the Meziere water pump was installed and fired up, it started to rub on the upper radiator hose after the hose swelled after the engine warmed up. It didn’t rub through or cause any damage at all with the exception of rubbing a line of the black paint off the end of the water pump. The makeshift bracket isn’t the prettiest but it works well and keeps a good distance between the pump and the hose. (See pics)
- Old 6 rib pulleys included (in trunk).
- I only fill up with Shell or Chevron or good quality gas, 91 or higher and normally put octane booster in ea. tank unless I mix 100 octane with it.
- On one of the key fobs, the key ring attachment broke, so I have silicon tape wrapped around it so it will stay on the key ring. Key fob still works, no issues.
- The oil pressure gauge mounted on the pillar is non-operative. I never saw the reason to hook it up when there is an oil pressure gauge on the dash panel. Just didn't want to leave an empty spot on the pillar mount.
- There are 3 gauges mounted on the pillar, oil pressure, boost, and fuel pressure. The boost and fuel pressure gauges illumination light bulbs are out. I have replacement bulbs but have not gotten around to putting them in. I absolutely hate taking the pillar off to be honest. They will be included (in center console).
- The driver’s side dust boot on the rack and pinion is torn in one spot. Does not leak any fluid as the seals inside are not damaged. Just the dust boot.
- The throttle body spring is weak....need to feather the gas when coming off of her hard, normal driving is fine. Not a lot, just a quick stab at the throttle should do. Never got around to calling Accufab about it, never really bothered me.
-When under extreme boost and from smashing it, the rubber sleeve between the intake pipe and the throttle body will come off. It comes off only at the throttle body end, intake pipe end is fine. Again it only happens when you boost the crap out of it. Haven’t figured out a way to keep it on under that much pressure. I even mounted heavy duty T-Bolt Clamps to each end and it helped a lot but it still pops off under extreme boost only. If you torque the hell out of the T-Bolt (throttle body end only), they hold the rubber sleeve longer under extreme boost. But sooner or later the sleeve will come off and I just put it back on and tighten. Only comes off under full boost and if you're romping on her all the time. Does not come off under normal driving conditions.
- When the shop took off the supercharger during the 8 Rib upgrade, I am almost 100% sure that they must did something to the blower. It never leaked before and after they finished they told me there was a small oil leak from the blower. It’s a very slow leak, almost 2 months before it hit the “minimum” oil level line. It drips onto the tensioner arm, and has NOT come in contact with the belt, even while driving. I contacted ProCharger and they quoted a few hundred to tear apart and put new seals in. I never sent it in as I had originally planned on sending it in and upgraded it to the D1SC, which would put out more HP and TQ. They said $1500 for the D1SC upgrade. Can still be driven just fine as the leak is VERY slow, I just check it before I drive and after, and there is no noticeable difference after operation.
- Rock and curb chips on the lower front bumper.
- I wasn’t paying attention one day, and pulled too far into a parking space and the curb lifted the front bumper up and broke the plastic part of the top mounts in the engine bay (see pics). This did not make the bumper fall off as there are other mounts elsewhere that were undamaged, but I zip tied them cause it annoyed me, and it actually holds better/stiffer that way.
- Needs to be Re-tuned! After I installed the Meziere Electric Water Pump and went from a 3.20” supercharger pulley to a 2.90”, I have not had it re-tuned. I have not driven it hard (only about 85 miles, been sitting ever since) since the changes but can feel a big difference in the performance with more boost (It comes on faster/harder at lower RPM’s) Going to assume it will be around 18-19 lbs of boost after the re-tune with the smaller pulley and electric water pump.
- ABS sensor light will come on after about 10-15 min of driving. Started coming on when I put the Nitto 555R’s (305/40/18) on. Never bothered with it since I don’t smash the gas and brakes everywhere I go and I rarely drive it as it is. Maybe just needs a new ABS sensor…not sure.
Test drives welcome…I promise you, you will not be disappointed. Local pickups encouraged. I reserve to end the auction early as the vehicle is for sale locally also.
*ATTN CA BUYERS
I will get it smogged for you, then after that it is up to you once you take ownership. Will take about 1-2 weeks to get the smog certificate.
She is not perfect, but is still a beauty to behold and a monster to drive. I have listed all the info, mods, cons, etc., to the best of my ability. If there are any questions, please do not hesitate to contact my cell# (831) 261-1818.
||$16000 - Loan
||Or Best Offer - Get
a pre-approved loan
|For Sale By:
ads posted by Justin
||Reply to Ad